| Register | FAQ | Calendar | Mark Forums Read |
|
|
||||
7th January 2003, 19:05
|
#1 |
|
Dee Hast Mish
|
computers that Hissssssss
|
|
|
7th January 2003, 19:07
|
#2 |
|
simulationszeitalter
|
noooo... poor snakey! D:
|
|
|
|
7th January 2003, 21:30
|
#3 |
|
|
ewwww!
Better then it slithering through your pipes and coming out of your toilet I guess.. |
|
|
|
7th January 2003, 22:03
|
#4 |
|
|
this is old and the snake is fake
|
|
|
|
8th January 2003, 01:04
|
#5 | |
|
Antagonist Prime
|
Quote:
I argued that it was fake till I was blue in the face, please tell me you have evidence to back that up? |
|
|
|
|
8th January 2003, 03:37
|
#6 |
|
|
heh, funny. fake or not.
|
|
|
|
8th January 2003, 04:19
|
#7 |
|
|
Notice how it's body doesn't change shape when draped over the screw driver shaft? And how would it get it's head out of the fan? I doubt it'd want to get out until the computer was turned on. It'd try to and get fapped in the face by a fan blade.
lame, sucka. |
|
|
|
8th January 2003, 06:14
|
#8 |
|
|
couldn't it of had its head through the fan blade, then when the fan tried to rotate it wouldn't because it was blocked, that would explain the twisting of the area just under its head.
It does look real to me, and Firewall o_O |
|
|
|
8th January 2003, 06:35
|
#9 | |
|
|
Quote:
Lady turns computer on, as snake is half way out of fan, blade starts turning, gets no further, H4X0rs snake... hence why is was half way out?... i dunno if its real or not, but if i had to choose, id pick real. |
|
|
|
|
8th January 2003, 09:55
|
#10 |
|
|
The snake is pretty real looking.
|
|
|
|
8th January 2003, 10:14
|
#11 |
|
|
It looks pretty beat up in the last pic, looks like it's got burns and stuff.
It looks fake in the upside down pic though. Wouldn't like to put any money on whether it's fake or not. |
|
|
|
8th January 2003, 10:17
|
#12 |
|
|
look at the inside shot of the snake
as well as getting cut up by the fan it should have caused the psu to blow as its lying on all the fucking traces and crap and IF that aint proof a spinning psu fan can cut a finger up when starting from scratch you cant completely cut your finger off with a spade as it hits bone but you can cut a snake in half with a spade as its only muscel therefore a snake is weaker than a mans finger meaning it should get fucked up more than a finger if left in a psu fan the snake aint fucked up so its a fake |
|
|
|
8th January 2003, 10:19
|
#13 |
|
|
Maybe it wasn't on when the snake crawled in?
|
|
|
|
8th January 2003, 10:24
|
#14 |
|
|
BS, a PSU fan wouldn't fuck you up unless you stuck your finger into it when it was going full tilt. Even then you'd only come off with a little bit of bruising, or maybe a really small cut if you were unlucky.
|
|
|
|
8th January 2003, 10:32
|
#15 |
|
|
I lived in queensland for 2 years and am pretty sure you could buy rubber snakes that look very similar to that one.
Given that it is the University of Queensland website it smells of a hoax to me. Pretty funny though. My 2c |
|
|
|
8th January 2003, 11:07
|
#16 | |
|
|
Quote:
|
|
|
|
|
8th January 2003, 11:08
|
#17 | |
|
|
Quote:
|
|
|
|
|
8th January 2003, 11:13
|
#18 | |
|
|
Quote:
|
|
|
|
|
8th January 2003, 11:14
|
#19 | |
|
|
Quote:
|
|
|
|
|
8th January 2003, 11:38
|
#20 | ||
|
|
Quote:
Quote:
However the more I read other articles about it the more I seem to believe it Last edited by VERT : 8th January 2003 at 11:39. |
||
|
|
|
8th January 2003, 12:19
|
#21 |
|
|
__________________
this statement is unprovable |
|
|
|
8th January 2003, 12:20
|
#22 |
|
Impatient Patient
|
a snake is not just muscle, it has a skeleton too...
and snakes look like that from underneath, they are very rubbery and it didnt move or drop cos probly been dead for awhile and you know how living things get stiff after dying.... and you can cut right thru your finger with a spade, if you hit hard enough the bone will just shatter, also it could go thru the join... Last edited by AcidFang : 8th January 2003 at 12:22. |
|
|
